Verilink WANsuite 6x30 (34-00315.B) Product Manual - Manual (Page 131)

V T 1 0 0 I n t e r f a c e 4-33
Service Aware
The Service Aware function recognizes IP traffic on the WAN and counts the
number of frames and bytes passed for a specific service based on filters by
VPI/VCI, by IP Address, and by IP Port. Each row of the Service Aware table
represents a specific set of filter parameters known as a “rule.” Each rule is
established through the Rule Config screen, which is accessed by selecting
“Rule Details.”
The Service Aware screen (Figure 4.29) provides a table showing these
filtered packet counts for up to 10 rules. This table indicates which Service
Aware filters are enabled or disabled, and shows the specific VPI/VCI, IP
Address, and IP Port by which the IP traffic is filtered. In addition, this table
shows the Tx Alarm Threshold and the current Tx Alarm status (if enabled)
for each rule.
Figure 4.29 Service Aware Screen
Rule Config Screen
Use the Rule Config screen (Figure 4.30) to establish Service Aware
parameters. To establish a rule, select the desired rule configuration options,
provide the appropriate filter information where required, and press the “Esc”
key.