Verilink WANsuite 6x30 (34-00315.B) Product Manual - Manual (Page 140)

4-42 W A N s u i t e 6 x 3 0
Figure 4.39 Circuit Details Screen
E n d p oin t Endpoint name. By default, the first circuit is always the LAN circuit. WAN
circuit endpoint names are taken from the VPI/VCI number. For example,
VPI 0/VCI 32 will have “P0-C32” for an endpoint name. The pull-down
menu will display a list of VPI/VCIs actually configured. A given circuit will
receive/transmit data on the VPI/VCI combination corresponding to its
endpoint name.
IP A d d ress IP Address of the circuit.
IP M a sk IP Mask of the circuit.
M a x Tra n sm it U n it Maximum transmit unit this circuit will send at any one time.
C ost Represents the relative time of treatment of an IP packet. This value is used
when there are multiple routes to the same destination. When two or more
routes are available, the one with the lowest circuit cost is selected. A frame
relay circuit should have a higher value than a LAN circuit.
R IP S ta tu s Indicates whether or not RIP is enabled on this circuit.
Values: Enable, Disable
Default: Enable
M u ltica st S ta tu s Indicates whether or not Multicast is enabled on this circuit.
Values: Enable, Disable
Default: Enable
O S P F S ta tu s Indicates whether or not OSPF is enabled on this circuit.
Values: Enable, Disable
Default: Disable
O S P F A rea Represents that area that this circuit is part of.