Verilink WANsuite 6x30 (34-00315.B) Product Manual - Manual (Page 53)

W e b S e r v e r I n t e r f a c e 3-25
The Serial screen provides the following user-activated buttons:
To make changes to a Serial port parameter, simply set the parameter to the
desired selection and press the “Submit” button.
10/100 Ethernet Screen (IP Service Details)
The 10/100 Ethernet (IP Service Details) screen (Figure 3.20) lets you
configure the IP parameters described below.
Figure 3.20 10/100 Ethernet (IP Service Details) Screen
U n it IP A d d ress A unique Network address assigned to this unit.
S u b n et M a sk Defines the Network portion of the unit’s IP address.
G atew a y IP A d d ress IP address of the default gateway (router) on the LAN side of the unit.
D H C P C lien t If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and
Gateway addresses from a DHCP server located on the LAN side of the unit,
and the unit will use these addresses. If the DHCP request is unsuccessful, the
unit will use the configured addresses shown on this screen.
NOTICE: To use newly established IP parameters, you must “Submit” and “Save
and Restart.” (See Save and Restart on page 3-4.) The parameters
above can also be configured using the Installation Wizard on page 2-2.
To view details about the current condition of IP, ICMP (In and Out), TCP,
and UDP parameters, click on the “Ethernet Stats” button at the bottom of the
screen. The Ethernet Stats screen (Figure 3.21) contains no user-selectable
fields or options; it is simply a representation of the applicable MIB II
parameters.
Button Function
Submit Sets any values that have been changed.
Serial Services Displays the Services screen for the Serial interface.
Refresh Refreshes data on the current page.