Verilink WANsuite 6x30 (34-00315.B) Product Manual - Manual (Page 156)

4-58 W A N s u i t e 6 x 3 0
N AT IP A d d ress Translated IP Address of the host.
T x P a ck ets Number of packets sent from NAT.
P rocessed P a ck ets Number of packets processed by NAT for this address.
Static UDP Translation Table Screen
The Static UDP Translation Table screen (Figure 4.56) allows static mapping
of global UDP Server ports to a local host IP address/port combination. The
parameters described below enable access to UDP Servers on the private/
corporate network “behind the NAT.” The parameters may be used only when
in NAPT mode.
Figure 4.56 Static UDP Translation Table Screen
G lob al P ort Decimal IP Port exposed to the global Internet. Default is 0.
S erver P ort Decimal IP Port of the local UDP Server. This port is usually the same as the
Global Port. Default is 0.
S erv er A d d ress IP Address of the local UDP Server. Default is 0.0.0.0.
You can configure or change the above-listed parameters on the Static UDP
Translation Details screen (Figure 4.57), which is accessed by selecting the
appropriate number under the <Ndx> column on the Static UDP Translation
Table screen.