Verilink WANsuite 6x30 (34-00315.B) Product Manual - Manual (Page 29)

W e b S e r v e r I n t e r f a c e 3-1
C H A P T E R
3
C HAPTER 3
W
EB
S
ER VER
I
N TER FA C E
The WANsuite 6x30 product family supports the major SNMP Management
Information Bases (MIBs) that make configuration standard and easy to
manage. The MIBs may be accessed in a variety of ways. One is to use a
standard MIB browser of your choice (such as HP OpenView). A second is
through the intelligent Web Server interface that resides in your WANsuite
unit's internal memory. The Web Server interface and how it’s used to
configure your WANsuite unit are described in detail below.
In cases where all WANsuite 6x30’s unit Web Server configuration screens
are the same, only the 6130 screens are displayed. However, where the
configuration screens of the units differ, as in the case of the Network
Interface screens and their submenus, each unit’s configuration screens are
displayed. Even when all screens resemble each other, parameter values and/
or defaults may vary from unit to unit; these differences are noted.
Accessing the Web Server Interface
You can access the Web Server interface by connecting to its IP address. This
connection can be directly through the 10/100 Ethernet port, PPP over the
Supervisory port, or in-band via RFC 1483 encapsulated IP traffic on the
ATM circuit.
NOTICE: Any changes to the unit’s configuration MUST be followed by a
“Submit” (if there is a “Submit” button on the screen) and a “Save and
Restart” for the changes to take effect.
To view the Web Server interface, use Microsoft’s Internet Explorer 5.0 or
higher.
NOTICE: Verilink recommends Microsoft’s Internet Explorer 5.0 (or higher). If
you use other Internet browsers to access the Web Server interface,
screen elements will not display as described in this manual.