Verilink WANsuite 6x30 (34-00315.B) Product Manual - Manual (Page 23)

A b o u t t h e W A N s u i t e 6 x 3 0 1-7
Ethernet LED Indicators
There are two unlabeled indicator LEDs on either side of the 10/100 Ethernet
jack. The LED on the left side of the jack pulses amber to indicate data
activity (either transmit or receive). The LED on the right side of the jack
lights green to indicate that the link layer is operational.
Serial Interface
The SERIAL interface located on WANsuite 6x30 rear panels is a multi-
protocol interface presented physically as a DB-25 connection. The protocols
supported by this interface are RS-232, V.35, EIA-530, and (on the 6230
only) X.21.
Cables that adapt the DB-25 interface to the 34-pin V.35 interface are
available. DB-25 to DB-25 cables are also available if your installation needs
require them. See Standard Equipment on page A-10 for details. Pin
assignments for the Serial interface are listed in Serial Interface Pin
Assignments, DTE Mode (Packet Use Only) on page A-11 and Serial Interface
Pin Assignments, DCE Mode on page A-12.
CAUTION: FCC rules require that interconnecting cables carrying high-speed
data be shielded appropriately to minimize radio frequency
interference.
Network Interface
The WANsuite 6x30 units have one rear panel NETWORK connection. On the
WANsuite 6130 and 6430, this connection is a standard RJ-48C, eight-pin
modular jack that terminates as 120 ohms. The WANsuite 6230’s Network
port is accessible through either the 75- or 120-ohm jack. The 75-ohm
connectors are standard BNC jacks, while the 120-ohm connector is a
standard RJ-48C right-pin modular jack. Both 75- and 120-ohm jacks will
receive a signal level to
−
27 dB to its appropriate termination impedance.
To view the pinout assignments for these interfaces, refer to Network Interface
Pin Assignments on page A-13.
Power Connection
The POWER port on the WANsuite 6130 and 6230 units is an eight-pin
circular mini-DIN connector that connects the autoranging 100–240 VAC or
18
−
150 VDC external power supply to the unit. The WANsuite 6230 is
intended to be used with a CE Marked power supply with a minimum output
rating of 4.0 A at +5 VDC. The unit has no power switch.
The POWER port on the WANsuite 6430 unit is a standard, grounded, three-
prong connector. This 110/220 VAC power receptacle is rated at 50–60 Hz,
0.2 A/0.1 A. To apply power to the unit, simply plug the supplied power cord