Verilink WANsuite 6x30 (34-00315.B) Product Manual - Manual (Page 142)

4-44 W A N s u i t e 6 x 3 0
Figure 4.40 Static Route Table Screen
E n d p oin t Endpoint name (or interface) through which to send the IP packet to reach the
Target IP Address. By default, the first circuit is always the LAN circuit.
WAN circuit endpoint names are taken from the VPI/VCI number. For
example, VPI 0/VCI 32 will have “P0-C32” for an endpoint name. The pull-
down menu will display a list of VPI/VCIs actually confirmed. A given
circuit will receive/transmit data on the VPI/VCI combination corresponding
to its endpoint name.
Ta rg et IP A d d ress Represents the target network that you want this router to reach.
Ta rg et IP M a sk Mask of the target network.
N ex t H o p IP address of the next device in the route.
C ost Cost of using that route.
R te S ta t Indicates whether a route is enabled or disabled.
Routes Details Screen
Selecting a number from the <Ndx> column will display the screen shown in
Figure 4.41. This screen is used to establish the configuration parameters of a
given route.
To establish a new route or to change the parameters of an existing route,
enter the desired values in the available parameter fields and press the “Esc”
key.