Verilink WANsuite 6x30 (34-00315.B) Product Manual - Manual (Page 22)

1-6 W A N s u i t e 6 x 3 0
The rear panel of the WANsuite 6230 has seven connectors. From left to
right, these are as follows:
POWER, SUPERVISORY PORT, 10/100 ETHERNET,
SERIAL , and NET (75
Ω
Rx), NET (75
Ω
Tx), NET (120
Ω
) as shown in Figure
1.3 below. The WANsuite 6230 has one E1 port to which you may connect
using either the 75-ohm BNC or the 120-ohm RJ-48C.
Figure 1.3 WANsuite 6230 Rear Panel
The rear panel of the WANsuite 6430 has five connectors. From left to right,
these are as follows:
POWER , SUPERVISORY PORT , 10/100 ETHERNET ,
SERIAL , and NETWORK as shown in Figure 1.4 below.
Figure 1.4 WANsuite 6430 Rear Panel
Supervisory Port
The SUPERVISORY port is a DB-9 female DCE connector configured for 8
bits, no parity, and 1 stop bit. Bit rates are configured through the Web server
interface. (See Supervisory Screen on page 3-26.) The Supervisory port speed
can be set to 1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200 bps.
The initial default rate of the Supervisory port is 19200 bps.
On power-up, the Supervisory port sends out diagnostic messages at the bit
rate of 115.2 kbps until the Supervisory service acquires the Supervisory port,
after which the port speed is changed to the setting in the Supervisory
interface screen.
NOTICE: For information on pinout assignments for this connector, refer to
Supervisory Port Pin Assignments on page A-13. See Standard
Equipment on page A-10 for information on cables for this connector.
10/100 Ethernet
The WANsuite 6x30 units provide a single 10/100 ETHERNET interface for IP
Gateway, SNMP, and Web browser access. This interface is an eight-pin
modular jack that complies with standard twisted-pair, 10/100Base-T
requirements. The 10/100Base-T cable is supplied by the end user. Refer to
Ethernet Connection Pin Assignments on page A-12 for pin assignments and
cable descriptions.