TA Triumph-Adler FAX 950 - Manual (Page 114)

Duplex Fax Reception ON/OFF
If Duplex fax reception is turned ON, it is possible to receive incoming
faxes on the front and reverse paper sides.
* If an uneven number of documents is received, or if the last page of
a transmission ends on the front side of the paper, there will be
nothing printed on the reverse side of that paper. The next
document that is received will be printed on the front side of a new
sheet of paper.
* Split page reception (when a received document is divided and
printed onto multiple sheets of paper because the received page
was larger than the paper in the cassette) may not be used together
with Duplex fax reception.
* To cancel the procedure part way through, press the STOP key.
The message display will revert to the initial mode.
* If Restricted access is turned ON, it is first necessary to enter the
registered management password and then press the ENTER
FUNCTION key. Refer to “(5) Entering Your Access Code”, page 7-28.
1. Press the FUNCTION key.
2. Press the ( 씱 ) cursor key until the following message appears in
the message display.
3. Press the ENTER FUNCTION key.
4. Press the ( 씱 ) cursor key until the following message appears in
the message display.
5. Press the ENTER FUNCTION key.
6. Use the cursor keys ( 씱 ) ( 씰 ) to select whether you want to turn
Duplex fax reception ON or OFF.
7. Press the ENTER FUNCTION key.
8. Press the STOP key. The message display will revert to the initial
mode.
9-8
6HFWLRQ
Other Settings and Registration
 
 
6(7 '2&80(17
)81&7,21
6(77,1*
6(77,1*
'83/(;5;6(/(&7
'83/(;5;6(/(&7
21
'83/(;5;6(/(&7
2))
Setting the Paper Size
Register here which size of paper will be used. Select from between
A4 and FOLIO sizes by carrying out the following procedure.
* The factory default setting is A4. Therefore, there is no need to
change this setting during the initial set-up procedure if you will be
using A4 size paper.
* To cancel the procedure part way through, press the STOP key.
The message display will revert to the initial mode.
* If Restricted access is turned ON, it is first necessary to enter the
registered management password and then press the ENTER
FUNCTION key. Refer to “(5) Entering Your Access Code”, page 7-28.
1. Press the FUNCTION key.
2. Press the ( 씱 ) cursor key until the following message appears in
the message display.
3. Press the ENTER FUNCTION key.
4. Press the ( 씱 ) cursor key until the following message appears in
the message display.
5. Press the ENTER FUNCTION key.
6. Press the cursor keys ( 씱 ) ( 씰 ) until the desired paper size appears
in the message display.
7. Press the ENTER FUNCTION key.
8. Press the STOP key. The message display will revert to the initial
mode.
 
 
6(7 '2&80(17
)81&7,21
6(77,1*
6(77,1*
&$66(77( 3$3(5 6,=(
6(7 3$3(5 6,=(
$
6(7 3$3(5 6,=(
)2/,2