TA Triumph-Adler FAX 950 - Manual (Page 19)

2-7
6HFWLRQ
Fax Operation (Basic)
4
4. Insert the clip on one side of the paper stop plate into the
appropriate hole in the paper cassette corresponding to the
size of paper to be set, and then place the centre clip and
the clip on the opposite side into their respective holes as
well.
* MAKE SURE that the clips are properly inserted into the
cassette and that the cassette stop plate is firmly in place.
5
5. Set the paper in the paper cassette.
* MAKE SURE that the paper is set under the claws located
on both sides of the paper cassette.
6
6. Reinsert the paper cassette in the facsimile.
(4) Connecting the Power Cord
Plug one end of the power cord into the power receptacle and
the other end into the power outlet in the room.
(5) Warm Up
Once the power cord is connected to the facsimile and an outlet, the
fax will begin to warm up.
Warm up normally requires less than 30 seconds.
Once the fax has warmed up, it will automatically enter the initial
mode (waiting for operation).
NOTE
Once warm up begins, a message will appear in the message
display.
In order to change the language used in the message display and on
printed reports and lists, refer to “Message Display and Report/Lists
Language”, page 9-4.
 
 
6(7 '2&80(17