TA Triumph-Adler FAX 950 - Manual (Page 63)

6-3
6HFWLRQ
Troubleshooting
● “CALL SERVICEMAN”
Serviceman intervention is required. After confirming the letter of the
alphabet shown in the message display, contact your service
representative, an authorised service centre or the place of purchase.
● “SYSTEM ERROR”
Serviceman intervention is required. Disconnect the power cord and
contact your service representative, an authorised service centre or
the place of purchase.
● “MEMORY FULL / CHANGE TO ADF TX”
The memory has reached its capacity while scanning in documents
for transmission. All data scanned to that point will be deleted.
Remove and then reset the documents on the document table and
switch to the Direct Feed transmission mode or, in order to transmit in
the Memory transmission mode, clear sufficient space in memory and
then attempt to transmit again. (Refer to “Transmission mode”,
page 2-13.)
● “CHANGE TO LINE [
;
]? / YES”
The memory has reached its capacity while scanning in documents
with the optional Dual Line Kit installed.
Use the cursor keys (
씱 ) ( 씰 ) to select whether or not you want to
change the line. Then press the ENTER FUNCTION key.
• Selecting “YES” will change the line and the transmission can be
attempted again. Reset all ejected documents and press the START
key.
• Selecting “NO” will cancel the transmission and the message
display will return to the initial mode.
* This message will only be displayed when Transmission line priority
is turned OFF.
● “MEMORY FULL”
The memory has reached its capacity while scanning in originals to
be copied. All data scanned to that point will be deleted. If you are
using the SUPER FINE or PHOTO MODE setting, reduce the
resolution setting to FINE. If you are using the FINE setting, reduce
the resolution setting to Normal and attempt to scan the originals
again.
● “HANG UP PHONE”
The receiver to the separately purchased telephone was not hung up
properly after communication. If the telephone is not in use, hang up
the receiver. If an alarm sounds as well, press the STOP key.
● “USED AS MEMORY FILE”
The abbreviated number, or one-touch or other key, that you
attempted to modify or delete was used to schedule a transmission.
Modify or delete that abbreviated number or one-touch key AFTER
the transmission is completed.
● “FILE OVERFLOW / CHANGE TO ADF TX”
The maximum of 50 Standby transmissions and communications
which use the timer have been scheduled in memory. Either switch to
and attempt the desired transmission in the Direct Feed transmission
mode, attempt the desired transmission AFTER one of the scheduled
communications is completed, or delete one of the communications
from memory and then attempt to transmit again.
A Power Failure Report is Printed
Out
If documents or other information contained in memory are lost due to
a power failure, a Power failure report will be printed out once power
is restored to the facsimile. Refer to this report to confirm what
information was lost.
* If no information was lost, a Power failure report will not be printed
out.
),/( 29(5)/2:
&+$1*( 72 $') 7;
86(' $6 0(025< ),/(
6<67(0 (5525
&$//6(59,&(0$1 +
0(025< )8//
&+$1*( 72 $') 7;
+$1*833+21(
0(025<)8//
&+$1*(72/,1(>@"
<(6