ProSoft Technology ILX34-AENWG - Manual (Page 144)

Ladder Logic ILX34-AENWG ♦ Point I/O Platform
User Manual Wireless POINT I/O Adapter
Page 144 of 177 ProSoft Technology, Inc.
August 16, 2013
Error Bit Description
6 A configuration was selected that requires the scalar and none was programmed OR
Multiple scalars were selected.
5 The preset is out of range (Rollover).
4 A rollover of zero was programmed through PWM was not selected OR
A rollover was programmed and PWM was selected OR
Rollover is out of range (>0x01000000).
3 A configuration requiring a time base was selected and no gate interval was set OR
Gate interval is out of range (>200) OR
Product of time base and gate interval is greater than 3 seconds.
2 A time base was entered that is not a multiple of 10 OR
Time base is out of range (>3000, or 3 seconds).
1 ZF/BF/AF were selected and no filter was programmed OR
Multiple filters were selected.
0 A reserved configuration/mode was programmed.
1734-IJ, 1734-IK
1734 POINT I/O Catalog Number RSLogix5000 Module Description
1734-IJ 1 Channel 5V dc Encoder / Counter
1734-IK 1 Channel 15…24V dc Encoder / Counter
Output Data Data Type Default Value Valid Data Values
Counter Control SINT 0
Counter Reset BIT 0 0 0=Count Unchanged
1=Count Cleared
Counter Preset BIT 1 0 0=Count Unchanged
1=Count Set to Preset
Value Reset
(Stored / Accumulated Count)
BIT 2 0 0=Count Unchanged
1=Count Cleared
1734-SSI
1734 POINT I/O Catalog Number RSLogix5000 Module Description
1734-SSI 1 Channel Synchronous Serial Interface
Configuration Data Data Type Default Value Valid Data Values
Run SINT 1 0=Module Not Running
1=Module Is Running
Gray Binary SINT 1 0=Binary Code
1=Gray Code
Word Length SINT 13 2…31