ProSoft Technology ILX34-AENWG - Manual (Page 20)

Start Here ILX34-AENWG ♦ Point I/O Platform
User Manual Wireless POINT I/O Adapter
Page 20 of 177 ProSoft Technology, Inc.
August 16, 2013
1.7.2 Configure One or More Repeaters (Optional)
The following illustration shows an example configuration for a RadioLinx
Industrial Hotspot (Access Point) configured as a Repeater radio. The need for
repeater radios is determined by the distance between the Master radio and the
ILX34-AENWG, as well as any topographical factors such as hills or other
obstructions, which could prevent a clear line-of-sight signal path.
Note: The radio in this illustration is capable of transmitting at 5 GHz (802.11a) as well as 2.4 GHz
(802.11b/g). The radio in the ILX34-AENWG adapter supports only 2.4 GHz (802.11b/g).
In particular, note the following settings.
 Network SSID, Channel, Encryption and Passphrase for the Repeater
radio must match those configured for the Master radio and the ILX34-
AENWG.
 IP Address: The IP address for all radios must be within the same subnet,
and each radio requires its own unique IP address. You can assign static IP
addresses, as in this example, or you can use DHCP (Dynamic Host Control
Protocol) to manage and assign IP addresses Configure the Adapter for Your
EtherNet/IP Network (page 24).
Note: Refer to the documentation for your radio (for example, the RLXIB-IHW User Manual) for
specific steps to configure the settings in this example.
1.8 Install the Adapter
Attention: You must use series C POINT I/O modules with the ILX34-AENWG adapter. Series A
or B POINT I/O modules will not work with this adapter.