ProSoft Technology ILX34-AENWG - Manual (Page 22)

Start Here ILX34-AENWG ♦ Point I/O Platform
User Manual Wireless POINT I/O Adapter
Page 22 of 177 ProSoft Technology, Inc.
August 16, 2013
2 Press down firmly to install the adapter on the DIN-rail, and then turn the
orange screw to lock the adaptor onto the DIN-rail.
Warning: If you connect or disconnect the Ethernet cable with power applied to this module or any
device on the network, an electrical arc can occur. This could cause an explosion in hazardous
location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
3 Slide the safety end cap up to remove. This exposes the backplane and
power interconnections.
Caution: Do not discard the end cap. Use this end cap to cover the exposed interconnections on
the last mounting base on the DIN-rail. Failure to do so could result in equipment damage or injury
from electric shock.
Important: You must use series C POINT I/O modules with the ILX34-AENWG adapter. Series A
or B POINT I/O modules will not work with this adapter.
1.8.3 Connect Power to the Adapter
The ILX34-AENWG adapter requires an external source of DC voltage. The DC
source voltage should be 24V nominal, with a range of 10V to 28.8V. Refer to the
following illustrations for wiring information.
Caution: Do not connect 120/240V ac power to this supply.
Warning: If you connect or disconnect wiring while the field-side power is on, an electrical arc can
occur. This could cause an explosion in hazardous location installations.