ProSoft Technology ILX34-AENWG User Manual
Page 27
ILX34-AENWG ♦ Point I/O Platform
Start Here
Wireless POINT I/O Adapter
User Manual
ProSoft Technology, Inc.
Page 27 of 177
August 16, 2013
3 Click the S
ET
button.
4 Click OK
to dismiss the confirmation dialog box.
5 Click the R
EFRESH
button to verify the changes.
Use the Rockwell BootP/DHCP Utility
The Rockwell B
OOT
P/DHCP utility is a stand-alone program that incorporates the
functionality of standard BootP software with a user-friendly graphical interface.
You can install BootP from the U
TILS
directory on the RSLogix5000 installation
DVD.
To use BootP, you must enable DHCP on ILX34-AENWG adapter, and the
adapter's network address switches must be set to a value greater than
Configure the IP Address with the Thumbwheel Switches (page 24).
To configure your adapter using the BootP utility, perform the following steps:
1 Run the BootP software.
In the BOOTP
R
EQUEST
H
ISTORY
pane, you will see the hardware addresses
of devices on the network that are issuing BootP requests.