Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 105)

D-Series CLI Reference 4-1
4
Port Configuration
This chapter describes the Port Configuration set of commands and how to use them.
Port Configuration Summary
Port String Syntax Used in the CLI
Commands requiring a port‐string parameter use the following syntax to designate port type, slot
location, and port number:
port type.unit number.port number
Where port type can be:
ge for 1‐Gbps Ethernet
host for the host port
vlan for vlan interfaces
lag for IEEE802.3 link aggregation ports
Where unit number is 1 for the D2 standalone unit, and
Port number can be:
1 – 12 for the D2G124‐12 and the D2G124‐12P
The highest valid port number is dependent on the number of ports in the device and the port
type.
For information about... Refer to page...
Port Configuration Summary 4-1
Reviewing Port Status 4-3
Disabling / Enabling and Naming Ports 4-7
Setting Speed and Duplex Mode 4-9
Enabling / Disabling Jumbo Frame Support 4-12
Setting Auto-Negotiation and Advertised Ability 4-14
Setting Flow Control 4-18
Setting Port Link Traps and Link Flap Detection 4-19
Configuring Broadcast Suppression 4-28
Port Mirroring 4-31
Link Aggregation Control Protocol (LACP) 4-33
Configuring Protected Ports 4-47