Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 53)

show system enhancedbuffermode
D-Series CLI Reference 2-15
show system enhancedbuffermode
Use this command to display the status of enhanced buffer mode, which optimizes buffer
distribution for single CoS queue operation.
Syntax
show system enhancedbuffermode
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to display enhanced buffer mode status:
D2(su)->show system enhancedbuffermode enable
Optimized system buffer distribution Disable
set system enhancedbuffermode
Use this command to enable or disable enhanced buffer mode, which optimizes buffer
distribution for single CoS queue operation. Executing this command will reset the switch, so the
system prompts you to confirm whether you want to proceed.
Syntax
set system enhancedbuffermode {enable | disable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to enable enhanced buffer mode:
D2(su)->set system enhancedbuffermode enable
Changes in the enhanced buffer mode will require resetting this unit.
Are you sure you want to continue? (y/n)
enable | disable Enables or disables enhanced buffer mode.