Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 367)

set sntp poll-interval
D-Series CLI Reference 12-29
set sntp poll-interval
Use this command to set the poll interval between SNTP unicast requests.
Syntax
set sntp poll-interval interval
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the SNTP poll interval to 30 seconds:
D2(su)->set sntp poll-interval 30
clear sntp poll-interval
Use this command to clear the poll interval between unicast SNTP requests.
Syntax
clear sntp poll-interval
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear the SNTP poll interval:
D2(su)->clear sntp poll-interval
set sntp poll-retry
Use this command to set the number of poll retries to a unicast SNTP server.
Syntax
set sntp poll-retry retry
interval Specifies the poll interval in seconds. Valid values are 16 to 16284.