Show multiauth port, Set multiauth port, Show multiauth port -34 set multiauth port -34 – Enterasys Networks Enterasys D2 D2G124-12P User Manual
Page 458
show multiauth port
15-34 Security Configuration
show multiauth port
Use this command to display multiple authentication properties for one or more ports.
Syntax
show multiauth port [port-string]
Parameters
Defaults
If port‐string is not specified, multiple authentication information will be displayed for all ports.
Mode
Switch command, read‐only.
Example
This example shows how to display multiple authentication information for ports
ge
.3.1‐4:
D2(rw)->show multiauth port ge.3.1-4
Port Mode Max Allowed Current
users users users
------------ ------------ ---------- ---------- ----------
ge.3.1 auth-opt
8
8
0
ge.3.2 auth-opt
8
8
0
ge.3.3 auth-opt
8
8
0
ge.3.4 auth-opt
8
8
0
set multiauth port
Use this command to set multiple authentication properties for one or more ports.
Syntax
set multiauth port mode {auth-opt | auth-reqd | force-auth | force-unauth} |
numusers numusers port-string
Parameters
port‐string
(Optional) Displays multiple authentication information for specific port(s).
mode
auth‐opt |
auth‐reqd |
force‐auth |
force‐unauth
Specifies the port(s)’ multiple authentication mode as:
•
auth‐opt — Authentication optional (“non‐strict” behavior). If a user
does not attempt to authenticate using 802.1x, or if 802.1x
authentication fails, the port will allow traffic to be forwarded
according to the defined default VLAN.
•
auth‐reqd — Authentication is required.
•
force‐auth — Authentication considered.
•
force‐unauth — Authentication disabled.
numusers
numusers
Specifies the number of users allowed authentication on port(s). Valid
values are 0 to 8.