Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 226)

set spantree portpri
6-34 Spanning Tree Configuration
Parameters
Defaults
If port‐string is not specified, port priority will be displayed for all Spanning Tree ports.
If sid is not specified, port priority will be displayed for Spanning Tree 0.
Mode
Switch command, read‐only.
Example
This example shows how to display the port priority for ge .2.7:
D2(su)->show spantree portpri port ge.2.7
Port ge.2.7 has a Port Priority of 128 on SID 0
set spantree portpri
Use this command to set a port’s Spanning Tree priority.
Syntax
set spantree portpri port-string priority [sid sid]
Parameters
Defaults
If sid is not specified, port priority will be set for Spanning Tree 0.
Mode
Switch command, read‐write.
Example
This example shows how to set the priority of ge .1.3 to 240 on SID 1
D2(su)->set spantree portpri ge.1.3 240 sid 1
port port‐string (Optional) Specifies the port(s) for which to display Spanning Tree priority.
For a detailed description of possible port‐string values, refer to “
Port String
Syntax Used in the CLI ” on page 4‐1.
sid sid (Optional) Displays port priority for a specific Spanning Tree identifier.
Valid values are 0 ‐ 4094. If not specified, SID 0 is assumed.
port‐string Specifies the port(s) for which to set Spanning Tree port priority. For a
detailed description of possible port‐string values, refer to “
Port String
Syntax Used in the CLI ” on page 4‐1.
priority Specifies a number that represents the priority of a link in a Spanning Tree
bridge. Valid values are from 0 to 240 (in increments of 16) with 0
indicating high priority.
sid sid (Optional) Sets port priority for a specific Spanning Tree identifier. Valid
values are 0 ‐ 4094. If not specified, SID 0 is assumed.