Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 406)

set dhcp pool
14-12 DHCP Server Configuration
set dhcp pool
Use this command to create and assign a name to a DHCP server pool of addresses. Up to 16
address pools may be configured on a D‐Series. Note that entering this command is not required
to create an address pool before configuring other address pool parameters.
Syntax
set dhcp pool poolname
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example creates an address pool named “auto1.”
D2(rw)->set dhcp pool auto1
clear dhcp pool
Use this command to delete a DHCP server pool of addresses.
Syntax
clear dhcp pool poolname
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example deletes the address pool named “auto1.”
D2(rw)->clear dhcp pool auto1
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.