Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 113)

set port alias
D-Series CLI Reference 4-9
set port alias
Use this command to assign an alias name to a port.
Syntax
set port alias port-string [name]
Parameters
Defaults
If name is not specified, the alias assigned to the port will be cleared.
Mode
Switch command, read‐write.
Examples
This example shows how to assign the alias “Admin” to ge .3.3:
D2(rw)->set port alias ge.3.3 Admin
This example shows how to clear the alias for ge .3.3:
D2(rw)->set port alias ge.3.3
Setting Speed and Duplex Mode
Purpose
To review and set the operational speed in Mbps and the default duplex mode: Half, for half
duplex, or Full, for full duplex for one or more ports.
Commands
port‐string Specifies the port to which an alias will be assigned. For a detailed
description of possible port‐string values, refer to “
Port String Syntax
Used in the CLI ” on page 4‐1.
name (Optional) Assigns an alias name to the port. If the alias name contains
spaces, the text string must be surrounded by double quotes. Maximum
length is 60 characters.
Note: These settings only take effect on ports that have auto-negotiation disabled.
For information about... Refer to page...
show port speed 4-10
set port speed 4-10
show port duplex 4-11
set port duplex 4-14