Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 326)

clear port txq
10-8 Port Priority and Rate Limiting Configuration
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Usage
Queues can be set for strict priority (SP) or weighted round‐robin (WRR). If set for WRR mode,
weights may be assigned to those queues with this command. Weights are specified in the range
of 0 to 100 percent. Weights specified for queues 0 through 7 on any port must total 100 percent.
Examples
This example shows how to change the arbitration values for the eight transmit queues belonging
to
ge .1.1:
D2(su)->set port txq ge.1.1 10 10 10 10 10 10 10 30
This example shows how to change the algorithm to strict priority for the eight transmit queues
belonging to
ge .1.1:
D2(su)->set port txq ge.1.1 0 0 0 0 0 O O 100
D2(su)->show port txq ge.1.1
Port Alg Q0 Q1 Q2 Q3 Q4 Q5 Q6 Q7
----- --- --- --- --- --- --- --- --- ---
ge.1.1 STR SP SP SP SP SP SP SP SP
clear port txq
Use this command to clear port transmit queue values back to their default values.
Syntax
clear port txq port-string
port‐string Specifies port(s) on which to set queue arbitration values. For a detailed
description of possible port‐string values, refer to “
Port String Syntax Used
in the CLI ” on page 4‐1.
Only physical ports can be configured with this command. LAG ports
cannot be configured.
value0 ‐ value7 Specifies percentage to allocate to a specific transmit queue. The values
must total 100 percent.