Show dhcp conflict, Clear dhcp conflict, Show dhcp conflict -5 clear dhcp conflict -5 – Enterasys Networks Enterasys D2 D2G124-12P User Manual
Page 399
show dhcp conflict
D-Series CLI Reference 14-5
show dhcp conflict
Use this command to display conflict information, for one address or all addresses.
Syntax
show dhcp conflict [address]
Parameters
Defaults
If no address is specified, conflict information for all addresses is displayed.
Mode
Read‐only.
Example
This example displays conflict information for all addresses. Note that ping is the only detection
method used.
D2(ro)->show dhcp conflict
IP address Detection Method Detection Time
----------- ----------------- ---------------
192.0.0.2 Ping 0 days 19h:01m:23s
192.0.0.3 Ping 0 days 19h:00m:46s
192.0.0.4 Ping 0 days 19h:01m:25s
192.0.0.12 Ping 0 days 19h:01m:26s
clear dhcp conflict
Use this command to clear conflict information for one or all addresses, or to disable conflict
logging.
Syntax
clear dhcp conflict {logging | ip-address| *}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
address
[Optional] Specifies the address for which to display conflict information.
logging
Disables conflict logging.
ip‐address
Clears the conflict information for the specified IP address.
*
Clears the conflict information for all IP addresses.