Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 65)

set console baud
D-Series CLI Reference 2-27
Mode
Switch command, read‐only.
Example
This example shows how to display all console settings:
D2(su)->show console
Baud Flow Bits StopBits Parity
------ ------- ---- ---------- ------
9600 Disable 8 1 none
set console baud
Use this command to set the console port baud rate.
Syntax
set console baud rate
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the console port baud rate to 19200:
D2(su)->set console baud 19200
Activating Licensed Features
In order to enable the D2 advanced features, such as Policy, you must purchase and activate a
license key. If you have purchased a license, you can proceed to activate your license as described
in this section. If you wish to obtain a permanent or evaluation license, use the Enterasys
Customer Portal or contact the Enterasys Networks Sales Department.
rate Sets the console baud rate. Valid values are: 300, 600, 1200, 2400, 4800, 5760,
9600, 14400, 19200, 38400, and 115200.