Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 404)

clear dhcp server statistics
14-10 DHCP Server Configuration
clear dhcp server statistics
Use this command to clear all DHCP server counters.
Syntax
clear dhcp server statistics
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example clears all DHCP server counters.
D2(rw)->clear dhcp server statistics
Configuring IP Address Pools
Manual Pool Configuration Considerations
• The subnet of the IP address being issued should be on the same subnet as the ingress
interface (that is, the subnet of the host IP address of the switch, or if routing interfaces are
configured, the subnet of the routing interface).
• A manual pool can be configured using either the client’s hardware address (set dhcp pool
hardware‐address) or the client’s client‐identifier (set dhcp pool client‐identifier), but using
both is not recommended.
• If the incoming DHCP request packet contains a client‐identifier, then a manual pool
configured with that client‐identifier must exist on the switch in order for the request to be
processed. The hardware address is not checked.
• A hardware address and type (Ethernet or IEEE 802) configured in a manual pool is checked
only when a client‐identifier is not also configured for the pool and the incoming DHCP
request packet does not include a client‐identifier option.
Purpose
To configure and clear DHCP address pool parameters, and to display address pool configuration
information.
Note: A total of 16 address pools, dynamic and/or static, can be configured on the D-Series .