Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 95)

set cdp state
D-Series CLI Reference 3-3
set cdp state
Use this command to enable or disable the CDP discovery protocol on one or more ports.
Syntax
set cdp state {auto | disable | enable} [port-string]
Parameters
Defaults
If port‐string is not specified, the CDP state will be globally set.
Mode
Switch command, read‐write.
Examples
This example shows how to globally enable CDP:
D2(su)->set cdp state enable
This example shows how to enable the CDP for port ge .1.2:
D2(su)->set cdp state enable ge.1.2
This example shows how to disable the CDP for port ge .1.2:
D2(su)->set cdp state disable ge.1.2
set cdp auth
Use this command to set a global CDP authentication code.
Syntax
set cdp auth auth-code
Status Whether CDP is enabled, disabled or auto-enabled on the port.
Table 3-8 show cdp Output Details (Continued)
Output Field What It Displays...
auto | disable |
enable Auto‐enables, disables or enables the CDP protocol on the specified port(s).
In auto‐enable mode, which is the default mode for all ports, a port
automatically becomes CDP‐enabled upon receiving its first CDP message.
port‐string (Optional) Enables or disables CDP on specific port(s). For a detailed
description of possible port‐string values, refer to
“ Port String Syntax Used in
the CLI ” on page 4‐1.