Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 363)

Configuring Simple Network Time Protocol (SNTP)
D-Series CLI Reference 12-25
Configuring Simple Network Time Protocol (SNTP)
Purpose
To configure the Simple Network Time Protocol (SNTP), which synchronizes device clocks in a
network.
Commands
show sntp
Use this command to display SNTP client settings.
Syntax
show sntp
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Note: A host IP address must be configured on the D2 to support SNTP.
For information about... Refer to page...
show sntp 12-25
set sntp client 12-27
clear sntp client 12-27
set sntp server 12-28
clear sntp server 12-28
set sntp poll-interval 12-29
clear sntp poll-interval 12-29
set sntp poll-retry 12-29
clear sntp poll-retry 12-30
set sntp poll-timeout 12-30
clear sntp poll-timeout 12-31