Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 93)

D-Series CLI Reference 3-1
3
Discovery Protocol Configuration
This chapter describes how to configure discovery protocols.
Configuring CDP
Purpose
To review and configure the Enterasys CDP discovery protocol. This protocol is used to discover
network topology. When enabled, this protocol allows Enterasys devices to send periodic PDUs
about themselves to neighboring devices.
Commands
The commands used to review and configure the CDP discovery protocol are listed below.
show cdp
Use this command to display the status of the CDP discovery protocol and message interval on
one or more ports.
Syntax
show cdp [port-string]
For information about... Refer to page...
Configuring CDP 3-1
Configuring Cisco Discovery Protocol 3-6
For information about... Refer to page...
show cdp 3-1
set cdp state 3-3
set cdp auth 3-3
set cdp interval 3-4
set cdp hold-time 3-5
clear cdp 3-5
show neighbors 3-6