Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 71)

set port inlinepower
D-Series CLI Reference 2-33
Example
This example shows how to display PoE information for port ge.2.1 . In this case, the port’s
administrative state, PoE priority and class have not been changed from default values:
D2(su)->show port inlinepower ge.2.1
Port Type
Admin Oper Priority Class Power(W)
---- ---- ----- ---- -------- ----- --------
ge.2.1 wireless auto searching low 0 15.4
set port inlinepower
Use this command to configure PoE parameters on one or more ports.
Syntax
set port inlinepower port-string {[admin {off | auto}] [priority {critical | high
| low}] [type type]}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to enable PoE on port ge .3.1 with critical priority:
D2(su)->set port inlinepower ge.3.1 admin auto priority critical
Downloading a Firmware Image
You can upgrade the operational firmware in the D‐Series switch without physically opening the
switch or being in the same location. There are two ways to download firmware to the switch:
• Via TFTP download. This procedure uses a TFTP server connected to the network and
downloads the firmware using the TFTP protocol. For details on how to perform a TFTP
download using the copy command, refer to “
copy ” on page 2‐45. For information on setting
TFTP timeout and retry parameters, refer to “ set tftp timeout ” on page 2‐47 and “ set tftp
retry ” on page 2‐48.
• Via the serial (console) port. This procedure is an out‐of‐band operation that copies the
firmware through the serial port to the switch. It should be used in cases when you cannot
connect the switch to perform the in‐band copy download procedure via TFTP. Serial console
download has been successfully tested with the following applications:
port‐string Specifies the port(s) on which to configure PoE.
admin off | auto Sets the PoE administrative state to off (disabled) or auto (on).
priority critical |
high | low Sets the port(s) priority for the PoE allocation algorithm to critical
(highest), high or low.
type type Specifies a string describing the type of device connected to a port.