Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 391)

clear rmon filter
D-Series CLI Reference 13-19
Defaults
If owner is not specified, it will be set to monitor.
If no other options are specified, none (0) will be applied.
Mode
Switch command, read‐write.
Example
This example shows how to create RMON filter 1 and apply it to channel 9:
D2(rw)->set rmon filter 1 9 offset 30 data 0a154305 dmask ffffffff
clear rmon filter
Use this command to clear an RMON filter entry.
Syntax
clear rmon filter {index index | channel channel}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear RMON filter entry 1:
D2(rw)->clear rmon filter index 1
dmask dmask (Optional) Specifies the mask applied to data to indicate which bits are
significant.
dnotmask dnotmask (Optional) Specifies the inversion mask that indicates which bits should
be set or not set.
owner (Optional) Specifies the name of the entity that configured this entry.
index index |
channel channel Clears a specific filter entry, or all entries belonging to a specific channel.