Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 87)

Clearing and Closing the CLI
D-Series CLI Reference 2-49
Example
This example shows how to clear the retry value to the default of 5 retries.
D2(rw)-> clear tftp retry
Clearing and Closing the CLI
Purpose
To clear the CLI screen or to close your CLI session.
Commands
The commands used to clear and close the CLI session are listed below.
cls (clear screen)
Use this command to clear the screen for the current CLI session.
Syntax
cls
Parameters
None .
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to clear the CLI screen:
D2(su)->cls
exit
Use either of these commands to leave a CLI session.
Syntax
exit
For information about... Refer to page...
cls 2-49
exit 2-49