Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 120)

set port advertise
4-16 Port Configuration
Parameters
Defaults
If port‐string is not specified, advertisement for all ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display advertisement status for Gigabit ports 13 and 14:
D2(su)->show port advertise ge.1.13-14
ge.1.13 capability advertised remote
-------------------------------------------------
10BASE-T yes yes yes
10BASE-TFD yes yes yes
100BASE-TX yes yes yes
100BASE-TXFD yes yes yes
1000BASE-T no no no
1000BASE-TFD yes yes yes
pause yes yes no
ge.1.14 capability advertised remote
-------------------------------------------------
10BASE-T yes yes yes
10BASE-TFD yes yes yes
100BASE-TX yes yes yes
100BASE-TXFD yes yes yes
1000BASE-T no no no
1000BASE-TFD yes yes yes
pause yes yes no
set port advertise
Use this command to configure what a port will advertise for speed/duplex capabilities in auto‐
negotiation.
Syntax
set port advertise {port-string}{10t | 10tfd | 100tx | 100txfd | 1000t | 1000tfd
| pause}
Parameters
port‐string (Optional) Displays advertised ability for specific port(s). For a
detailed description of possible port‐string values, refer to “
Port
String Syntax Used in the CLI ” on page 4‐1.
port‐string Select the ports for which to configure advertisements. For a detailed
description of possible port‐string values, refer to “
Port String Syntax Used
in the CLI ” on page 4‐1.
10t Advertise 10BASE‐T half duplex mode.
10tfd Advertise 10BASE‐T full duplex mode.
100tx Advertise 100BASE‐TX half duplex mode.