Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 371)

clear nodealias config
D-Series CLI Reference 12-33
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Usage
Upon packet reception, node aliases are dynamically assigned to ports enabled with an alias
agent, which is the default setting on D‐Series devices. Node aliases cannot be statically created,
but can be deleted using the clear node alias command as described in “
clear nodealias config ” on
page 12‐33.
Example
This example shows how to disable the node alias agent on ge .1.3:
D2(su)->set nodealias disable ge.1.3
clear nodealias config
Use this command to reset node alias state to enabled and clear the maximum entries value.
Syntax
clear nodealias config port-string
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the node alias configuration on ge .1.3 :
D2(su)->clear nodealias config ge.1.3
enable | disable Enables or disables a node alias agent.
maxentries maxentries Set the maximum number of alias entries per ports. Valid range is 0 to
4096. The default value is 32.
port‐string Specifies the port(s) on which to enable/disable node alias agent or set
a maximum number of entries.
port‐string Specifies the port(s) on which to reset the node alias configuration.