Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 445)

show macauthentication session
D-Series CLI Reference 15-21
show macauthentication session
Use this command to display the active MAC authenticated sessions.
Syntax
show macauthentication session
Parameters
None.
Defaults
If port‐string is not specified, MAC session information will be displayed for all MAC
authentication ports.
Mode
Switch command, read‐only.
Usage
Changing the Reauth Period with the set macauthentication reauthperiod command does not
affect current sessions. New sessions display the correct period.
Port username
significant bits Number of significant bits in the MAC addresses to be used starting with the left-
most bit of the vendor portion of the MAC address. The significant portion of the MAC
address is sent as a user-name credential when the primary attempt to authenticate
the full MAC address fails. Any other failure to authenticate the full address, (i.e.,
authentication server timeout) causes the next attempt to start once again with a full
MAC authentication. Default value of 48 can be changed with the set
macauthentication significant-bits command.
Port Port designation. For a detailed description of possible port-string values, refer to
“
Port String Syntax Used in the CLI ” on page 4-1.
Port State Whether or not MAC authentication is enabled or disabled on this port.
Reauth Period Reauthentication period for this port. Default value of 30 can be changed using the
set macauthentication reauthperiod command (page 15-28).
Auth Allowed Number of concurrent authentications supported on this port. Default is 1 and cannot
be reset.
Auth Allocated Maximum number of MAC authentications permitted on this port. Default is 1 and
cannot be reset
Reauthentications Whether or not reauthentication is enabled or disabled on this port. Set using the set
macauthentication reauthentication command (page 15-26).
Table 15-48 show macauthentication Output Details (Continued)
Output Field What It Displays...