Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 39)

D-Series CLI Reference 2-1
2
Basic Configuration
At startup, the D‐Series switch is configured with many defaults and standard features. This
chapter describes how to customize basic system settings to adapt to your work environment.
Quick Start Setup Commands
The tables in this section provide a quick reference for the CLI commands needed to begin basic
D2 switch operation.
Table 2‐3 lists tasks and their associated CLI commands required for setting
up the switch with the latest firmware. Table 2‐4 lists optional CLI commands that will help you
perform additional basic configuration on the switch. Refer to the pages listed for more
information about each command.
For information about... Refer to page...
Quick Start Setup Commands 2-1
Setting User Accounts and Passwords 2-2
Setting Basic Switch Properties 2-8
Activating Licensed Features 2-27
Configuring System Power and Power over Ethernet (PoE) 2-30
Downloading a Firmware Image 2-33
Reviewing and Selecting a Boot Firmware Image 2-36
Starting and Configuring Telnet 2-37
Managing Switch Configuration and Files 2-39
Clearing and Closing the CLI 2-49
Resetting the Switch 2-50
Using and Configuring WebView 2-51
Table 2-3 Required CLI Setup Commands
Step Task CLI commands
Refer to
page...
1 Set a new password. set password [username] 2-5
2 Set the switch IP address. set ip address ip-address [mask
ip-mask] [gateway ip-gateway] 2-9
3 Download, activate, and verify new
firmware on the switch using TFTP
copy. copy tftp://tftp_server_ip_address/
filename system:image 2-45
set boot system filename 2-37
show version 2-22