Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 378)

set rmon history
13-6 RMON Configuration
Parameters
Defaults
If port‐string is not specified, information about all RMON history entries will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display RMON history entries for Gigabit Ethernet port 1 in switch 1.
A control entry displays first, followed by actual entries corresponding to the control entry. In this
case, the default settings for entry owner, sampling interval, and maximum number of entries.
(buckets) have not been changed from their default values. For a description of the types of
statistics shown, refer to
Table 13‐44 .
: D2(su)->show rmon history ge.1.1
Port: ge.1.1
-------------------------------------
Index 1
Owner = monitor
Status = valid
Data Source = ifIndex.1
Interval = 30
Buckets Requested = 50
Buckets Granted = 10
Sample 2779 Interval Start: 1 days 0 hours 2 minutes 22 seconds
Drop Events = 0 Undersize Pkts = 0
Octets = 0 Oversize Pkts = 0
Packets = 0 Fragments = 0
Broadcast Pkts = 0 Jabbers = 0
Multicast Pkts = 0 Collisions = 0
CRC Align Errors = 0 Utilization(%) = 0
set rmon history
Use this command to configure an RMON history entry.
Syntax
set rmon history index [port-string] [buckets buckets] [interval interval] [owner
owner]
Parameters
port‐string (Optional) Displays RMON history entries for specific port(s).
index‐list Specifies an index number for this entry.
port‐string (Optional) Assigns this entry to a specific port.
buckets buckets (Optional) Specifies the maximum number of entries to maintain.
interval interval (Optional) Specifies the sampling interval in seconds.
owner owner (Optional) Specifies an owner for this entry.