Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 417)

clear dhcp pool dns-server
D-Series CLI Reference 14-23
Syntax
set dhcp pool poolname dns-server address [address2 ... address8]
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example assigns a DNS server at 10.14.10.1 to the address pool “‘auto1.”
D2(rw)->set dhcp pool auto1 dns-server 10.14.10.1
clear dhcp pool dns-server
Use this command to remove the DNS server list from the address pool being configured.
Syntax
clear dhcp pool poolname dns-server
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example removes the DNS server list from the address pool “auto1.”
D2(rw)->clear dhcp pool auto1 dns-server
set dhcp pool domain-name
Use this command to specify a domain name to be assigned to DHCP clients served by the
address pool being configured.
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.
address Specifies the IP address of a DNS server.
address2 ... address8 (Optional) Specifies, in order of preference, up to 7 additional DNS
server addresses.
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.