Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 249)

set vlan name
D-Series CLI Reference 7-5
Mode
Switch command, read‐write.
Usage
Once a VLAN is created, you can assign it a name using the set vlan name command described in
“
set vlan name ” on page 7‐5.
Each VLAN ID must be unique. If a duplicate VLAN ID is entered, the device assumes that the
Administrator intends to modify the existing VLAN.
Enter the VLAN ID using a unique number between 1 and 4093. The VLAN IDs of 0 and 4094 and
higher may not be used for user‐defined VLANs.
Examples
This example shows how to create VLAN 3:
D2(su)->set vlan create 3
set vlan name
Use this command to set or change the ASCII name for a new or existing VLAN.
Syntax
set vlan name vlan-list vlan-name
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the name for VLAN 7 to green:
D2(su)->set vlan name 7 green
clear vlan
Use this command to remove a static VLAN from the list of VLANs recognized by the device.
Syntax
clear vlan vlan-list
vlan‐list Specifies the VLAN ID of the VLAN(s) to be named.
vlan‐name Specifies the string used as the name of the VLAN (1 to 32 characters).