Enterasys Networks Enterasys D2 D2G124-12P User Manual
Page 31
Factory Default Settings
D-Series CLI Reference 1-3
Link aggregation flow
regeneration
Disabled.
Link aggregation system
priority
Set to 32768 for all ports.
Link aggregation outport
algorithm
Set to DIP-SIP.
Lockout
Set to disable Read-Write and Read-Only users, and to lockout the default
admin (Super User) account for 15 minutes, after 3 failed login attempts.
Logging
Syslog port set to UDP port number 514. Logging severity level set to 6
(significant conditions) for all applications.
MAC aging time
Set to 300 seconds.
MAC locking
Disabled (globally and on all ports).
Passwords
Set to an empty string for all default user accounts. User must press ENTER
at the password prompt to access CLI.
Password aging
Disabled.
Password history
No passwords are checked for duplication.
Policy classification
Classification rules are automatically enabled when created.
Port auto-negotiation
Enabled on all ports.
Port advertised ability
Maximum ability advertised on all ports.
Port broadcast suppression Enabled and set to limit broadcast packets to 14,881 per second on all switch
ports.
Port duplex mode
Set to half duplex, except for 100BASE-FX and 1000BASE-X, which is set to
full duplex.
Port enable/disable
Enabled.
Port priority
Set to 0.
Port speed
Set to 10 Mbps, except for 1000BASE-X, which is set to 1000 Mbps, and
100BASE-FX, which is set to 100 Mbps.
Port trap
All ports are enabled to send link traps.
Power over Ethernet port
admin state
Administrative state is on (auto).
Priority classification
Classification rules are automatically enabled when created.
RADIUS client
Disabled.
RADIUS last resort action
When the client is enabled, set to Challenge.
RADIUS retries
When the client is enabled, set to 3.
RADIUS timeout
When the client is enabled, set to 20 seconds.
Rate limiting
Disabled (globally and on all ports).
SNMP
Enabled.
SNTP
Disabled.
Spanning Tree
Globally enabled and enabled on all ports.
Table 1-1 Default Settings for Basic Switch Operation (Continued)
Feature
Default Setting