Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 129)

set linkflap action
D-Series CLI Reference 4-25
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the link flap interval on port ge .1.4 to 1000 seconds.
D2(rw)->set linkflap interval ge.1.4 1000
set linkflap action
Use this command to set reactions to a link flap violation.
Syntax
set linkflap action port-string {disableInterface | gensyslogentry | gentrap |
all}
Parameters
Defaults
None.
Mode
Switch mode, read‐write.
Example
This example shows how to set the link flap violation action on port ge .1.4 to generating a Syslog
entry.
D2(rw)->set linkflap action ge.1.4 gensyslogentry
clear linkflap action
Use this command to clear reactions to a link flap violation.
Syntax
clear linkflap action [port-string] {disableInterface | gensyslogentry | gentrap
| all}
port‐string Specifies the port(s) on which to set the link flap action.
disableInterface Sets the reaction as disabling the interface.
gensyslogentry Sets the reaction as generating a syslog entry.
gentrap Sets the reaction as generating an SNMP trap.
all Sets the reaction as all of the above.