Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 130)

set linkflap threshold
4-26 Port Configuration
Parameters
Defaults
If port‐string is not specified, actions will be cleared on all ports.
Mode
Switch mode, read‐write.
Example
This example shows how to clear the link flap violation action on port ge .1.4 to generating a
Syslog entry.
D2(rw)->clear linkflap action ge.1.4 gensyslogentry
set linkflap threshold
Use this command to set the link flap action trigger count.
Syntax
set linkflap threshold port-string threshold-value
Parameters
Defaults
None.
Mode
Switch mode, read‐write.
Example
This example shows how to set the link flap threshold on port ge .1.4 to 5.
D2(rw)->set linkflap threshold ge.1.4 5
port‐string (Optional) Specifies the port(s) on which to clear the link flap action.
disableInterface Clears the reaction as disabling the interface.
gensyslogentry Clears the reaction as generating a syslog entry.
gentrap Clears the reaction as generating an SNMP trap.
all Clears the reaction as all of the above.
port‐string Specifies the port(s) on which to set the link flap action trigger count.
threshold‐value Specifies the number of link down transitions necessary to trigger the
link flap action. A minimum of 1 must be configured.