Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 189)

show snmp notifyprofile
D-Series CLI Reference 5-35
Example
This example shows how to delete the SNMP notify filter “pilot1”:
D2(su)->clear snmp notifyfilter pilot1 subtree 1.3.6
show snmp notifyprofile
Use this command to display SNMP notify profile information. This associates target parameters
to an SNMP notify filter to determine who should not receive SNMP notifications.
Syntax
show snmp notifyprofile [profile] [targetparam targetparam] [volatile |
nonvolatile | read-only]
Parameters
Defaults
If no parameters are specified, all notify profile information will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display SNMP notify information for the profile named “area51”:
D2(su)->show snmp notifyprofile area51
--- SNMP notifyProfile information ---
Notify Profile = area51
TargetParam = v3ExampleParams
Storage type = nonVolatile
Row status = active
set snmp notifyprofile
Use this command to create an SNMP notify filter profile configuration. This associates a
notification filter, created with the set snmp notifyfilter command (“
set snmp notifyfilter ” on
page 5‐33), to a set of SNMP target parameters to determine which management targets should
not receive SNMP notifications.
Syntax
set snmp notifyprofile profile targetparam targetparam [volatile | nonvolatile]
profile (Optional) Displays a specific notify profile.
targetparam
targetparam (Optional) Displays entries for a specific target parameter.
volatile |
nonvolatile | read‐
only (Optional) Displays notify filter entries of a specific storage type.