Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 370)

show nodealias config
12-32 Logging and Network Management
show nodealias config
Use this command to display node alias configuration settings on one or more ports.
Syntax
show nodealias config [port-string]
Parameters
Defaults
If port‐string is not specified, node alias configurations will be displayed for all ports.
Mode
Switch command, read‐only.
Example
This example shows how to display node alias configuration settings for ports ge .2.1 through 9:
D2(rw)->show nodealias config ge.2.1-9
Port Number Max Entries Used Entries Status
----------- ----------- ------------ ------
ge.2.1 16 0 Enable
ge.2.2 47 0 Enable
ge.2.3 47 2 Enable
ge.2.4 47 0 Enable
ge.2.5 47 0 Enable
ge.2.6 47 2 Enable
ge.2.7 47 0 Enable
ge.2.8 47 0 Enable
ge.2.9 4000 1 Enable
Table 12‐42 provides an explanation of the command output.
set nodealias
Use this command to enable or disable a node alias agent on one or more ports, or set the
maximum number of alias entries per port.
Syntax
set nodealias {enable | disable | maxentries maxentries} port-string
port‐string (Optional) Displays node alias configuration settings for specific port(s).
Table 12-42 show nodealias config Output Details
Output Field What It Displays...
Port Number Port designation.
Max Entries Maximum number of alias entries configured for this port.
Used Entries Number of alias entries (out of the maximum amount configured) already used by
this port.
Status Whether or not a node alias agent is enabled (default) or disabled on this port.