Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 310)

clear cos port-config
9-24 Policy Classification Configuration
Inbound Rate Limiting Port Configuration Entries
----------------------------------------------------------------------
Port Group Name :Default
Port Group :0
Port Type :0
Assigned Ports :none
----------------------------------------------------------------------
Port Group Name :Users
Port Group :1
Port Type :0
Assigned Ports :ge.1.1-46
----------------------------------------------------------------------
Port Group Name :Uplink
Port Group :2
Port Type :0
Assigned Ports :ge.1.47-48
----------------------------------------------------------------------
clear cos port-config
Use this command to clear inbound rate limiting groups or assigned ports.
Syntax
clear cos port-config irl {all | group-type-index {[entry] | [name] [ports]}}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Usage
The default port group 0.0 cannot be deleted.
irl Clear an IRL port group configuration.
all Clear all inbound rate limiting port‐config non‐default entries.
group‐type‐index Delete a specific port group or group name, or clear the ports from that
group. Valid entries are in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
entry Delete this non‐default inbound rate limiter entry.
name Clear the administratively assigned textual description of this port group
entry to its default.
ports Clear the ports assigned to this group to its default.