Show telnet, Set telnet, Show telnet -38 set telnet -38 – Enterasys Networks Enterasys D2 D2G124-12P User Manual
Page 76
show telnet
2-38 Basic Configuration
show telnet
Use this command to display the status of Telnet on the switch.
Syntax
show telnet
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display Telnet status:
D2(su)->show telnet
Telnet inbound is currently: ENABLED
Telnet outbound is currently: ENABLED
set telnet
Use this command to enable or disable Telnet on the switch.
Syntax
set telnet {enable | disable} [inbound | outbound | all]
Parameters
Defaults
If not specified, both inbound and outbound Telnet service will be enabled.
Mode
Switch command, read‐write.
Example
This example shows how to disable inbound and outbound Telnet services:
D2(su)->set telnet disable all
Disconnect all telnet sessions and disable now (y/n)? [n]: y
All telnet sessions have been terminated, telnet is now disabled.
enable | disable
Enables or disables Telnet services.
inbound |
outbound | all
(Optional) Specifies inbound service (the ability to Telnet to this switch),
outbound service (the ability to Telnet to other devices), or all (both
inbound and outbound).