Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 421)

set dhcp pool option
D-Series CLI Reference 14-27
Example
This example removes the NetBIOS node type from the address pool “auto1.”
D2(rw)->clear dhcp pool auto1 netbios-node-type
set dhcp pool option
Use this command to configure DHCP options, described in RFC 2132.
Syntax
set dhcp pool poolname option code {ascii string | hex string-list | ip address-
list}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Examples
This example configures DHCP option 19, which specifies whether the client should configure its
IP layer for packet forwarding. In this case, IP forwarding is enabled with the 01 value.
D2(rw)->set dhcp pool auto1 option 19 hex 01
This example configures DHCP option 72, which assigns one or more Web servers for DHCP
clients. In this case, two Web server addresses are configured.
D2(rw)->set dhcp pool auto1 option 72 ip 168.24.3.252 168.24.3.253
clear dhcp pool option
Use this command to remove a DHCP option from the address pool being configured.
Syntax
clear dhcp pool poolname option code
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.
code Specifies the DHCP option code, as defined in RFC 2132. Value can range
from 1 to 254.
ascii string Specifies the data in ASCII format. An ASCII character string containing a
space must be enclosed in quotations.
hex string‐list Specifies the data in HEX format. Up to 8 HEX strings can be entered.
ip address‐list Specifies the data in IP address format. Up to 8 IP addresses can be entered.