Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 85)

set tftp timeout
D-Series CLI Reference 2-47
Usage
The TFTP timeout value can be set with the set tftp timeout command. The TFTP retry value can
be set with the set tftp retry command.
Example
This example shows the output of this command.
D2(ro)->show tftp settings
TFTP packet timeout (seconds): 2
TFTP max retry: 5
set tftp timeout
Use this command to configure how long TFTP will wait for a reply of either an acknowledgement
packet or a data packet during a data transfer.
Syntax
set tftp timeout seconds
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example sets the timeout period to 4 seconds.
D2(rw)->set tftp timeout 4
clear tftp timeout
Use this command to reset the TFTP timeout value to the default value of 2 seconds.
Syntax
clear tftp timeout
Parameters
None.
Defaults
None.
seconds Specifies the number of seconds to wait for a reply. The valid range is
from 1 to 30 seconds. Default value is 2 seconds.