Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 261)

Setting the Host VLAN
D-Series CLI Reference 7-17
Setting the Host VLAN
Purpose
To configure a host VLAN that only select devices are allowed to access. This secures the host port
for management‐only tasks.
Commands
show host vlan
Use this command to display the current host VLAN.
Syntax
show host vlan
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the host VLAN:
D2(su)->show host vlan
Host vlan is 7.
set host vlan
Use this command to assign host status to a VLAN.
Syntax
set host vlan vlan-id
Note: The host port is the management entity of the device. Refer to “ Creating a Secure
Management VLAN ” on page 7-1 for more information.
For information about... Refer to page...
show host vlan 7-17
set host vlan 7-17
clear host vlan 7-18