Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 162)

show snmp user
5-8 SNMP Configuration
Commands
show snmp user
Use this command to display information about SNMP users. These are people registered to
access SNMP management.
Syntax
show snmp user [list] | [user] | [remote remote] [volatile | nonvolatile | read-
only]
Parameters
Defaults
If list is not specified, detailed SNMP information will be displayed.
If user is not specified, information about all SNMP users will be displayed.
If remote is not specified, user information about the local SNMP engine will be displayed.
If not specified, user information for all storage types will be displayed.
Mode
Switch command, read‐only.
For information about... Refer to page...
show snmp user 5-8
set snmp user 5-9
clear snmp user 5-10
show snmp group 5-11
set snmp group 5-12
clear snmp group 5-12
show snmp community 5-13
set snmp community 5-14
clear snmp community 5-14
list (Optional) Displays a list of registered SNMP user names.
user (Optional) Displays information about a specific user.
remote remote (Optional) Displays information about users on a specific remote SNMP
engine.
volatile | nonvolatile
| read‐only (Optional) Displays user information for a specified storage type.